2014-04-22 Aavid heat pipe exploration kit

Have you ever had a design with a hot component that was hard to reach? Or have you used a heat sink inside a sealed enclosure, only to find out that it did not cool your component as expected? Did you research heat pipes and reach a point where you wanted to do a quick test but “standard heat pipes” were not available for your quick mock-up?

Throughout the years, heat pipes have demonstrated to be an effective part of our thermal design “tool box” here at Aavid. Many of our customers have embraced their ability to solve thermal issues efficiently and cost effectively. As heat pipes are still a thermal device that is not fully understood by all of our customers, Aavid will be offering a kit that will provide you the ability to perform some preliminary evaluation and testing.
Aavid is very excited to introduce our Heat Pipe Exploration Kit within the next few months. The kit will include a large selection of heat pipes ranging from 4 - 8mm diameter and 150 – 300mm in length. We will also include evaporator and condenser blocks that may be temporarily or permanently attached, along with thermal grease and general guidelines and instructions.
 

Contents include:
30 Qty. 228.6mm Heat Pipes (10 each dia: 4mm, 6mm, 8mm)
30 Qty. 304.8mm Heat Pipes (10 each dia: 4mm, 6mm, 8mm)
30 Qty. 153.4mm in Heat Pipes (10 each dia: 4mm, 6mm, 8mm)
15 Qty. 40mm x 150mm Condenser Plates
15 Qty. 40mm x 150mm Condenser Caps
15 Qty. 40mm x 40mm Evaporator Plates (5 each dia: 4mm, 6mm, 8mm)
15 Qty. 40mm x 40mm Evaporator Caps (5 each dia: 4mm, 6mm, 8mm)
180 Qty. M3 Screws
1 Thermal Grease

 

© 2011 Nijkerk Electronics; All rights reserved